Essence We.R Betriebsanweisung PDF herunterladen (Seite 89)

Installation of the WeR@Home™ System

System User Guide

opposite to a window.

n The Camera should be placed in a position where it will capture images from the main point of entry.

n For maximal effective detection range, the center of the Camera should be installed 2.1 meters (6.9ft)

to 2.3m (7.5ft) above the floor.

Note: Lower positioning of the Camera will limit its detection range.

n For daytime coverage – the Camera must be mounted within 10m (33ft) of the desired coverage area.

n For both day and nighttime coverage – the Camera must be mounted within 6m (20ft) of the desired

coverage area.

n The Camera must be mounted within 700m (2300ft) (open air nominal) of the CCU.

n The wall mounting base includes eight (8) holes to allow maximum flexibility of installation.

Extra holes are punch-outs (covered with thin plastic) that may be removed if necessary.

3.6.2.2 Installing with Screws

1. Release the Camera wall mounting back cover by lifting the tab and pushing it forward as illustrated in

Figure 40 above.

2. For Flat Wall Mounting:

i. Use a flat screwdriver to remove the punch-outs 1 and 2 (see Figure 41 above).

ii. Place and hold the base on the desired mounting location and mark the drilling locations (the

above-mentioned punch-outs 1 and 2).

iii. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in the two (2)

screws.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 290 291

Keine Kommentare

Essence We.R Betriebsanweisung Seite 89